Stereo System User Manual

Measuring Waveforms
CSA8000B & TDS8000B User Manual
3-97
Overview Control el ements and resourcesTo deskew between channel s (cont.)
Set up the
reference
channel
5. Set up the channel to be used as the reference channel:
a Push the channel num bered butt on under Vertical
on the f ront panel .
b Use the Vertical SCALE knob and POSITION
knobs to display t he waveform edge to be
deskewed to fill the screen verti c ally.
6. Use the Horizontal SCALE knob and POSITION knobs
to display the waveform edges to be deskewed t o f ill the
screen horizontally.
Deskew the
channel
7. Set up the channel t o be deskewed: repeat step 5 for
the channel to be deskewed.
8. Push Vertical MENU front panel but ton, and from the
Vertical Setup dialog box, adjust the Deskew value (see
right) to make the edges of the reference and the
deskew channel coincide (or are as close as possi ble).
9. If you cannot align the edges completely, try selecting
the reference channel and adjusting its deskew.
Deskew
more channels
10. If you need to, you can deskew addi tional channels:
11. Turn off the channel just deskewed, and leave the
reference channel on.
12. Set up the channel to be deskewed: repeat st ep 7 and
step 8 for the new channel to be deskewed.
13. Continue this process for as many channels as you want
to deskew.
14. Disconnect the deskew hookup.
End of Procedure