User manual

Operator’s Checkout Procedure
1760 Series Component Waveform/Vector Monitor User Manual
2-14
Figure 2-5. Component waveform display (A123).
Press the PARADE/OVERLAY button. The PARADE indicator
lights, and the inputs previously selected for parade are
restored (in this case,
CH-A1, CH-A2, and CH-A3 from the
factory preset). During
PARADE (or OVERLAY) operation, a ll
input channel buttons (including
A123/B123) sequence
through A, B, both, and off. Press the
CH-A3/CH-B3 input
repeatedly until it sequences through B, both, off, and back
to A (
CH-A3 selected).
Press the
CH-A button. Note that this now adds to the display
rather than cancelling the previous i nput selection. Up to
four inputs can be shown in parade, and any additional
signals are overla id.
Press the
PARADE/OVERLAY button again. The CH-A1 and
CH-A2 signals are superimposed. Exit PARADE/OVERLAY
mode. Note that the inputs selected before entering parade or
overlay mode (B123) are restored.