User manual

At A Glance

1760 Series Component Waveform/Vector Monitor User Manual

2-6

H Without PARADE or OVERLAY selected, onl y one input

selection can be made at a time. Each input channel

button (including

A123 / B123) toggles between A

and B, and is ca ncelled when another input button is

pressed.

H With

PARADE or OVERLAY selected, multiple input

selections can be made; input buttons select

A, B,

both, or off, a nd do not cancel each other.

H Selecting

A123 provides a side-by-side display of the

CH-A1, CH-A2, and CH-A3 inputs (B123 displays the

CH-B1, CH-B2, and CH-B3 inputs). Selecting A123or

B123 turns off all other input channels. When

PARADE or OVERLAY is selected, A123 and B123 can

be displayed toge ther and in combination with othe r

inputs.

PARADE displays up to four input channels side-by-

side, with any additi onal inputs overlaid. Selec ting

PARADE displays the input channel(s) last selected

for

PARADE, allowing a custom configuration of

inputs. In

PARADE mode, the LINE/FIELD button

offers only two choices: one line and one field.

OVERLAY provides an overlaid display of all se-

lected inputs.

Push the desired menu button to enter that menu and enable

the associated functions. Push the button again to exit the

menu and disable the function. Refer t o page 3-7 for more

information about using menus.

FILTER allows choice of flat or filtered display of the

waveform signal.

CURSOR enables timing cursors, voltage cursors,

vector cursors and markers.

LIN SEL allows the selection of a single line or group

of lines for display.