User manual

Appendix C: User Service

1760 Series Component Waveform/Vector Monitor User Manual

C-3

3. To remove a bulb, position the tweezer tips on the thin,

flat portion of the bul b (close to the plastic socket).

Carefully pull the bulb stra ight out.

4. To install a new bulb, hold it with the tweezers as de-

scribed in step 3, position it in front of the socket, and

push the bulb until it snaps in place.

5. Replace the pa nel below the CRT, and press on both the

right and left sides of the panel until it snaps into place.

6. Replace the fi ve knobs below the CRT and tighten the

set screws.

Remove these five knobs

Remove this panel

Recess

(shaded portion)

Figure C-1. Graticule light replacement.