Data Sheet

Output impedance 50 Ω
Load impedance setting Selectable: 50 Ω, 1 Ω to 10.0 kΩ, High Z (Adjusts displayed amplitude according to selected load impedance)
Isolation 42 Vpk maximum to earth ground
Short-circuit protection Signal outputs are robust against permanent shorts against floating ground
Overcurrent protection When incoming current is greater than 250 mA, the output channels are protected with relays that disconnect the AFG from
the device under test. Connection can be resumed by user after removing the incoming current
General characteristics - Basic mode
Basic (AFG)
Run modes Continuous, Modulation, Sweep and Burst
Standard waveforms Sine, Square, Pulse, Ramp, More (Noise, DC,Sin(x)/x, Gaussian, Lorentz, Exponential Rise, Exponential Decay,
Haversine )
Arbitrary waveforms Sampling clock: 250 MSa/s, 1 GSa/s or 2 GSa/s (model and waveform length apply) Vertical resolution: 14 bits
Waveform length: 2 to 131,072 points
Sine
Frequency range
AFG31021 /
AFG31022
AFG31051 /
AFG31052
AFG31101 /
AFG31102
AFG31151 /
AFG31152
AFG31251 /
AFG31252
Continuous mode 1 μHz to 25 MHz 1 μHz to 50 MHz 1 μHz to 100
MHz
1 μHz to 150
MHz
1 μHz to 250
MHz
Burst mode 1 μHz to 12.5
MHz
1 μHz to 25 MHz 1 μHz to 50 MHz 1 μHz to 75 MHz 1 μHz to 125
MHz
Effective maximum
frequency out
AFG31021 /
AFG31022
AFG31051 /
AFG31052
AFG31101 /
AFG31102
AFG31151 /
AFG31152
AFG31251 /
AFG31252
25 MHz 50 MHz 100 MHz 150 MHz 250 MHz
Amplitude flatness (1 V
P-P
,
relative to 1`kHz)
Frequency range AFG31021, AFG31022,
AFG31051, AFG31052,
AFG31101, AFG31102
AFG31151, AFG31152,
AFG31251, AFG31252
< 5 MHz ±0.2 dB ±0.2dB
≥ 5 MHz to 25 MHz ----- ±0.3 dB
≥ 5 MHz to 100 MHz ±0.3 dB -----
> 25 MHz to 100 MHz ----- ±0.5 dB
> 100 MHz to 200 MHz ----- ±1.0 dB
> 200 MHz to 250 MHz ----- ±2.0 dB
AFG31000 Series Datasheet
www.tek.com 7