Datasheet
Specifications
All specifications are guaranteed unless noted otherwise. All specifications apply to all models unless noted otherwise.
Model overview
Model Sine frequency range Number of channels
AFG31021 25 MHz 1
AFG31051 50 MHz
AFG31101 100 MHz
AFG31151 150 MHz
AFG31251 250 MHz
AFG31022 25 MHz 2
AFG31052 50 MHz
AFG31102 100 MHz
AFG31152 150 MHz
AFG31252 250 MHz
Output characteristics
Amplitude
AFG31021 /
AFG31022
AFG31051 /
AFG31052
AFG31101 /
AFG31102
AFG31151 /
AFG31152
AFG31251 /
AFG31252
Range (into 50 Ω) ≤ 60 MHz: 1 mV
P-P
to 10 V
P-P
> 60 MHz to ≤ 80 MHz: 1 mV
P-P
to 8 V
P-P
> 80 MHz to ≤ 100 MHz: 1 mV
P-P
to 6 V
P-P
≤ 200 MHz: 1 mV
P-P
to 5 V
P-P
> 200 MHz to ≤ 250 MHz: 1 mV
P-P
to
4 V
P-P
Range (into open
circuit or High-Z)
≤ 60 MHz: 2 mV
P-P
to 20 V
P-P
> 60 MHz to ≤ 80 MHz: 2 mV
P-P
to 16 V
P-P
> 80 MHz to ≤ 100 MHz: 2 mV
P-P
to 12 V
P-P
≤ 200 MHz: 2 mV
P-P
to 10 V
P-P
> 200 MHz to ≤ 250 MHz: 2 mV
P-P
to
8 V
P-P
Accuracy ± (1% of setting +1 mV
P-P
)
(1 kHz sine, 0 V offset, amplitude > 1 mV
P-P
)
Resolution 0.1 mV
P-P
, 0.1 mV
RMS
, 1 mV, 0.1 dBm or 4 digits
Units Vpp, Vrms (excluding Arb and Noise), dBm (sine wave only), Volt (High Level and Low Level)
Offset
AFG31021 /
AFG31022
AFG31051 /
AFG31052
AFG31101 /
AFG31102
AFG31151 /
AFG31152
AFG31251 /
AFG31252
Range (into 50 Ω) ±(5 V
PK
- Amplitude
P-P
÷ 2) ±(2.5 V
PK
- Amplitude
P-P
÷ 2)
Range (into open
circuit or High-Z)
±(10 V
PK
- Amplitude
P-P
÷ 2) ±(5 V
PK
- Amplitude
P-P
÷ 2)
Accuracy ± (1% of |setting| +1 mV + 0.5% of Amplitude (V
P-P
))
Resolution 1 mV or 4 digits
Output impedance 50 Ω
Load impedance setting Selectable: 50 Ω, 1 Ω to 10.0 kΩ, High Z (Adjusts displayed amplitude according to selected load impedance)
Isolation 42 Vpk maximum to earth ground
Short-circuit protection Signal outputs are robust against permanent shorts against floating ground
Overcurrent protection When incoming current is greater than 250 mA, the output channels are protected with relays that disconnect the AFG from the
device under test. Connection can be resumed by user after removing the incoming current
AFG31000 Series
www.tektronix.com 5