Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
Operating basics
34
AFG1000 Series Quick Start User Manual
Generate noise
1.
Push the front-panel
Noise
waveform
button.
2.
Use the general
purpose knob or the
numeric keypad to
adjust Ampl, High,
Offset and Low.
NOTE: You cannot modulate, sweep, or burst a noise waveform.
Generate DC
1.
Push the front-panel
Arb button.
2.
Press Others.
3.
Press Built-in.
4.
Press Others.
5.
Select DC, press Select
to output a DC waveform.
NOTE: You cannot modulate, sweep, or burst a DC waveform.