Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
24
AFG1000 Series Quick Start User Manual
Operating basics
Quick tutorial: How to select a waveform and adjust parameters
If you are a beginning user, follow the steps described here to select a
waveform and adjust waveform parameters.
1.
Push the power button to turn on the instrument.
2.
Connect the Channel Output of the instrument to an oscilloscope input with a
BNC cable.
3.
Select a waveform.
4.
Enable the signal output.
5.
Observe the waveform displayed on the oscilloscope screen.
6.
Use the front-panel bezel buttons on the instrument to select a waveform
parameter.
7.
Select Frequency as the parameter to be changed.
8.
Change the frequency value using the numeric keypad.
9.
Change the waveform parameters using the general purpose knob and the
arrow keypad.