Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
20
AFG1000 Series Quick Start User Manual
Instrument front panel, interface, and rear panel
Select run mode
Push the Mod panel button, and then press one of the four Run Mode bezel
buttons to select the instrument signal output method. Modulation,
sweeping, and burst modes are only available in Ch1on the AFG1022.
1.
The default Run Mode
is Continuous.
2.
To select a modulated
waveform, press Mod.
3.
To select a sweep
waveform, press
Sweep.
See page 35 for
details on
sweeping
waveforms.
4.
To select a burst
waveform, press
Burst.