Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
Instrument front panel, interface, and rear panel
AFG1000 Series Quick Start User Manual
15
Parts of the screen interface
1
4
5
6
7
2
3
3
Item Description
1
Bezel menu: When you push a front panel button, the instrument displays
the corresponding menu on the right side of the screen. The menu shows
the options that are available when you press the unlabeled bezel buttons
directly to the right of the screen.
2
Graph / waveform display area: This part of the main display area shows
the signal as a graph or waveform.
3
Parameter display area: This part of the main display area shows active
parameters.
indicates Frequency Lock is on; indicates Amplitude
Lock is on.
4
Message display area: This part displays the load value
5
Message display area: This part displays the current channel.
6
Parameter display area: This part displays the period.
7
Message display area: This part displays the type of the current signal or
the current mode.