Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
Getting started
AFG1000 Series Quick Start User Manual
13
Equivalent output circuits
The following illustrations show the equivalent output circuits:
Legend for the following
images:
Output signals do not exceed
±10 V when the >50 Ω load
impedance is used.
A change to the load impedance (L) will affect the output window (maximum and
minimum levels) for a sine waveform as follows.
L = 50 Ω: -5 V to +5 V (10 V
p-p
)
L = High Z: -10 V to +10 V (20 V
p-p
)