Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
Getting started
AFG1000 Series Quick Start User Manual
3
Operating requirements
The following information and figure describe temperature, clearance, and power
supply operating requirements of the instrument.
229.16 mm
(9.02 in)
306.36 mm
(12.06 in)
111.16 mm
(4.38 in)
Figure 1: Instrument dimensions
Environmental
requirements
Clearance. When placing the instrument on a cart or bench, observing the
following clearance requirements:
Sides: 50 mm (2 in)
Rear: 50 mm (2 in)
Temperature. Before operating the instrument, ensure the ambient temperature is
between 0 °C to +40 °C (+32 °F to +104 °F).
CAUTION. To ensure proper cooling, keep both sides of the instrument clear of
obstructions.
Power supply
requirements
Source voltage and frequency. 220 - 240 VAC, 100 - 120 VAC , 50/60 Hz, CAT Ⅱ
.
Power Consumption. AFG1022: Less than 28 W
AFG1062: Less than 35 W
WARNING. To reduce the risk of fire and shock, ensure that the mains supply
voltage fluctuations do not exceed 10% of the operating voltage range.