User manual

Operating basics
AFG1022 Quick Start User Manual
43
7. Press Trigger to select
Internal, External or
Manual.
Internal means using
the internal trigger
source.
External means using
the Ext Trig/FSK/Burst
conne
ctor on the rear
panel to input the
external triggered signal.
Press Slope to switch
between Positive and
Negative.
Manual means choosing
manual trigger; in
Triggered Burst mode,
push the general
purpose knob on the
front panel to output a
burst signal.
To generate a gated burst
waveform
1. Select a waveform and
then push the front-panel
Mod button.
2. Press Burst.
NOTE: You cannot select
pulse, noise, or arb waveform
as a
carrier waveform.
3. Press
N Cycle/Gated to
select Gated
.
4. Press Start Phase to
set start phase. The
start phase defines the
initial phase where the
waveform output
begins at, and it may
vary from -360 to 360.
For an Arbitrary
Waveform, 0° is the
first waveform point.
5. Press Polarity to set
the polarity of the
gated burst waveform.