User manual

Operating basics
AFG1022 Quick Start User Manual
29
Create/Save a user-defined waveform
You can create a user-defined waveform, and save it in the internal memory or in
an external USB memory device.
1. Push the Arb panel button.
2. Press Editable .
3. Press New to enter arb
waveform edit menu.
4. Press Points to set the
number of
waveform
point
s to be edited. Use
the general purpose knob
to adjust parameters
directly or use the
numeric keypad to adjust
and then choose the
proper unit. X1, X1000.
The waveform points
range is 2 to 8192.
5. Press Intrpl to switch
Interpolation On/Off. On
means the points will be
connected with beelines;
Off means the voltages
between two consecutive
points will not change, and
the waveform looks like a
step-up one
.
6. Press Edit Points to
enter point edit sub
menu.
7. Press Point to set the
number of point to be
edited.
8. Press Voltage to set the
voltage of the point.
Repeat step 7 and 8 to
set voltages of the
corresponding points.
9. Press Write to enter file
system interface.