User manual

Instrument front panel, interface, and rear panel
AFG1022 Quick Start User Manual
19
Select run mode
Push the Mod panel button, and then press one of the four Run Mode bezel
buttons to select the instrument signal output method. Modulation,
sweeping, and burst modes are only available in Ch1.
1. The default Run Mode
is Continuous.
2. To select a modulated
waveform, press Mod.
3. To select a sweep
waveform, press
Sweep.
See page 33 for details
on sweeping
waveforms.
4. To select a burst
waveform, press
Burst.