Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
56
AFG1000 Series Quick Start User Manual
Appendix A: Line fuse replacement
The line fuse is in the plastic fuse box below the power line input on the rear panel.
WARNING. Disconnect the line cord at the rear panel and remove all test leads
connected to the instrument before replacing the line fuse. Failure to do so could
expose the operator to hazardous voltages that could result in personal injury or
death.
Use only the correct fuse type. Failure to do so could result in personal injury or
instrument damage.
Voltage
Fuse
100 - 120 V
250 V, F1AL
220 - 240 V
250 V, F0.5AL
To perform the line fuse replacement, follow these steps:
1.
Remove the power cord.
2.
Use a screwdriver to
remove the fuse box.
3.
Replace the fuse with a
new one, which should
match with the voltage;
install it into the fuse box
and then push the fuse
box back on to the rear
panel.