Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
Operating basics
AFG1000 Series Quick Start User Manual
51
15.
Press Output Setup to set
output load value. Press
CH1Load or CH2Load to
toggle 50 ohm and High Z. At
50 ohm status, use the general
purpose knob to adjust the
value on the current cursor and
use ◄ / ► to move cursor.
Use the numeric keypad to
adjust the parameters and then
choose proper unit. The load
range is 1 ohm to 10 kohm.
NOTE: Please setup the correct
load for right application.
16.
Press System to display the
submenu.
Language (See page 7, Select
a local language)
PowerOn (See page 5,
Change instrument settings at
power-on)
Set_to Default (See page 16,
Default setup)
17.
Press NextPage to enter next
submenu.
18.
Press Beeper to toggle the
beep sound Off and On.
19.
Press CLK Ref to toggle the
clock reference source
between Internal and External.
20.
Update firmware (See page
10, Update your instrument
firmware)