Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
16
AFG1000 Series Quick Start User Manual
Instrument front panel, interface, and rear panel
Default setup
When you want to restore the instrument settings to the default values, use the
front-panel Utility button as follows:
1.
Push the front-panel Utility button.
2.
Press System.
3.
Press Set_to Default.
4.
Select one of the following:
Select to recall the default settings; the
instrument will display a 1 kHz
frequency, 1 V
p-p
amplitude sine
waveform as the default setup.
Cancel to cancel the recall and return
to the previous menu.