Instructions
Table Of Contents
- Table of contents
- Preface
- Getting started
- General features
- Before installation
- Standard accessories
- Operating requirements
- Power the instrument on and off
- Change instrument settings at power-on
- Erase waveforms from memory
- Select a local language
- Protect your instrument from misuse
- General care
- Update your instrument firmware
- Equivalent output circuits
- Instrument front panel, interface, and rear panel
- Operating basics
- Quick tutorial: How to select a waveform and adjust parameters
- Quick tutorial: How to generate a sine waveform
- Quick tutorial: Instrument help system
- Generate a pulse waveform
- Generate a built-in waveform
- Create/save a user-defined waveform
- Recall a user-defined waveform
- Generate noise
- Generate DC
- Sweep a waveform
- Modulate a waveform
- Generate a burst waveform
- Copy channel setting
- USB memory device
- Utility menu
- Save/recall instrument setup
- Application examples
- Appendix A: Line fuse replacement
- Index
Getting started
6
AFG1000 Series Quick Start User Manual
Erase waveforms from memory
You can erase all waveforms from the instrument
internal memory using the
following procedure.
1.
Push the Arb panel button.
2.
Press Others.
3.
Press File browse to
enter the file system.
4.
Use the general purpose
knob to select INTER, and
then press Enter.
5.
Press Secure.
6.
Press Select to erase all
waveforms stored in
internal memory, or press
Cancel to cancel the
operation.