User's Guide

Gen2 BLE Sensor Family User Guide T0007796_UG_Portable Version 0.2
TEKTELIC Communications Inc. Page 21 of 30
4. Replace the PCBA and end-cap in the same orientation as before and push firmly to shut
as shown in Figure 2-4.
Figure 2-4: Replacing the PCBA and End-Cap
2.6.2 Battery Replacement Procedure for C-Cell Sensor Variants
The battery cover is marked with a battery symbol and uses Phillips Head H1 screws. This is the
cover that needs to be removed to replace the battery, NOT the feature cover on the opposite
side which is marked by a magnet symbol and uses Torx Head screws.
1. In a non-hazardous location, remove the battery cover by unscrewing the
4x phillips head screws using a size #1 phillips head screwdriver as shown in Figure 2-5.
Figure 2-5: Removing the Battery Cover Screws