User's Guide

Gen2 BLE Sensor Family User Guide T0007796_UG_Portable Version 0.2
TEKTELIC Communications Inc. Page 19 of 30
Once activated, the sensor will automatically begin the join process. To turn the sensor off, the
battery must be removed. To reset the device, the external reset button can be pushed; see
Section 3.4 for a description of the reset function.
Refer to Section 3.3 for the expected LED behaviour of the Tracker during the join process.
2.5 Mounting
The only mounting options for the portable sensor variants are the belt clip mount and the
lanyard mount.
For the belt-clip variants, simply slide the clip over a belt or other surface to mount.
For the lanyard-mount variants, simply clip the fastener of a lanyard into the loop on the top
piece of the enclosure.
2.6 Battery Replacement
2.6.1 Battery Replacement Procedure for AA-Cell Sensor Variants
1. There are case-release slots in the front and back of the enclosure near the bottom end-
cap. Using pliers or a similar tool, press on each of the case-release tabs until the lips
clear the edge and the end-cap is free as shown in Figure 2-2.