User's Guide

Smart Room Sensor (Gen4) User Guide T0007525_UG Version 1.0
TEKTELIC Communications Inc. Page 14 of 18
4 Operation, Alarms, and Management
4.1 Configuration
The Smart Room Sensor supports a full range of Over-the-Air (OTA) configuration options.
Specific technical details are available in the Room Sensor Technical Reference Manual [2]. All
configuration commands need to be sent OTA during a sensor’s downlink windows.
4.2 Default Configuration
The default configuration on the Smart Room Sensor is:
• Report Temperature and Humidity every one (1) hour.
• CO2 model only:
o Report the carbon dioxide (CO
2
) concentration every 15 (fifteen) minutes.
• PIR model only:
o Report motion after 1 (one) PIR event.
o Clear motion after 5 (five) minutes of no motion.
• CO2 & PIR model only:
o Report the carbon dioxide (CO
2
) concentration every 15 (fifteen) minutes.
o Report motion after 1 (one) PIR event.
o Clear motion after 5 (five) minutes of no motion.
4.3 LED Behaviour
During the join procedure:
• After the Sensor has gone through the initial boot procedure, the join procedure will
begin. During that time, the red LED will blink continuously until the sensor has joined a
network.
During normal operation:
• The green LED will blink when the Sensor transmits a packet.
• The red LED will blink when the Sensor receives a packet.