User's Guide

Smart Room Sensor (Gen4) User Guide T0007525_UG Version 1.0
TEKTELIC Communications Inc. Page 11 of 18
2 Installation
2.1 Included Product and Installation Material
The following items are included with each sensor:
• Smart Room Sensor
• Mounting Bracket
• User Guide
2.2 Safety Precautions
The following safety precautions should be observed:
• The Smart Room Sensor is intended for indoor use only.
• The Smart Room Sensor contains lithium batteries.
• NEVER allow small children near batteries: if a battery is swallowed, immediately seek
medical attention.
• To reduce risk of fire, explosion or chemical burns: replace only with approved 2xAA LTC
batteries; DO NOT recharge, disassemble, heat above 100°C (212°F) or incinerate battery.
2.3 Unpacking and Inspection
The following should be considered during the unpacking of a new Smart Room Sensor:
1. Inspect the shipping carton and report any significant damage to TEKTELIC.
2. Unpacking should be conducted in a clean and dry location.
3. Do not discard the shipping box or inserts as they will be required if a unit is returned for
repair or re-configuration.
2.4 Required Equipment for Installation
There are no tools required for Smart Room Sensor installation.
2.5 Smart Room Sensor Mounting
Smart Room Sensor is designed to be mounted using the supplied mounting bracket. The
bracket can be attached using screws or double-sided tape (not included).
When mounting on a vertical surface, ensure that the Room Sensor will not be orientated with
the case retaining screws towards the ceiling. This could cause the Room Sensor to accidently