Guide

20
ADD THE BACK AND THE SNAPS
Working on the underside of the wing, sew the
top side of the snap so that it matches up with the
bottom snap when connected. Connect this snap
with the positive pad on the right LED board. Tie a
knot and cut your thread
positive to positive
negative to negative!
Now thread your needle with non-conductive
thread. Take the belly panel and line it up with the
bottom of the front panel . Sew the belly piece over
the battery holder, leave a small opening on the top
so that you can access the battery!
Take the back body panel and sew the bottom and
sides back body piece to attach it to the front panel.
They should line up nicely!
B
R G
B
R G