User Manual

-Dati tecnici e caratteristiche soggetti a cambiamenti senza preavviso -Technische Daten und Eigenschaften mit Änderungen ohne Anzeige
-All the specifi cations are subject to change without notice - Données techniques et caracteristiques suiettes à des changements sans avis
56
SPEED - FASTER
6- UNPACKING
Before removing the packaging, check that it is intact, disputing and writing on the delivery note of the forwarding agent
any damage noted before signing it. After removing the packaging, check that the machinery is intact; in the event that
it is damaged, immediately notify the dealer by fax or registered mail with proof of delivery and if the damage is likely to
jeopardize the safety of the machine, do not proceed with the installation until the intervention of a qualifi ed technician.
All packaging (plastic bags, cardboard, nails, etc.) must not be left within reach of children and pets as a source of poten-
tial danger.
7- MACHINERY PLACEMENT
The machinery must be installed and tested in full compliance with safety laws, enforced rules and regulations.
The installer is required to verify any restrictions imposed by local authorities.
Things to avoid :
- Places exposed to direct sunlight.
- Closed sites with high temperatures and poor air exchange.
Remove the protective PVC fi lm from all sides.
For a good installation of the machinery with air-cooled condenser built into the motor compartment, you must ensure that
in the installation area nothing is obstructing the air vents necessary for the proper functioning of the machinery or of the
premises itself. Keep a minimum distance of 50 cm from the air inlet and outlet sides.
The machinery must be installed and leveled by adjusting the support feet, so as to ensure stability; any other different
installation solutions must be agreed and approved by the manufacturer. For the leveling of the heavy machinery, use
special lifters.
If the equipment is not leveled, its operation and the fl ow of condensated water can be compromised.
If the cabinet is supplied on wheels, place it on a level surface and block them before switching on the equipment.
Wait 24 hours after the placement of the machinery before operating it in order to allow the return of the oil to the com-
pressor and prevent its breakage.