Service Manual

Installing the Enclosure

Servicing the Control

Injection

Mixing

Pmp

46 47

Signal wiring must be

rated at least 300 V

Designed and

assembled in Canada

44 45

Power In

Disconnect All Power

Before Opening

Step 1

Disconnect the wiring terminal plugs by pulling down in the

lower wiring chamber and by pulling up in the upper wiring

chamber.

Step 2

There are two tabs located on the right side of the enclosure.

Insert a screwdriver into the top of the tab and gently pry the

tab away from the control while pulling the control toward you.

Repeat for the second tab.

Step 3

Pull the control toward you.

Step 4

Disconnect the two wiring plugs and remove the control.

Custom Panel

or Electrical Box

Wall or Panel Door

In the event that the control requires servicing or replacement, the control can be easily removed from the enclosure. This

allows all wiring and conduit to remain installed.

Step 5

The new control is now ready to be installed in the

reverse order.

• Install the control enclosure to a wall or to an electrical box.

•

Three wiring chamber dividers are included. The dividers

provide a barrier to keep low voltage wiring separated from

line voltage wiring.

•

If the dividers are not used, then low voltage circuits must

use wire rated at least 300 V.

To prevent the risk of personal injury and/or death, make sure power is not applied to the control until it is fully

installed and ready for final testing. All work must be done with power to the circuit being worked on turned off.

Please be aware local codes may require this control to be installed or connected by an electrician.