Install Instructions

3 of 44 © 2020 654_D - 02/20
The installer must ensure that this control and its wiring are
isolated and/or shielded from strong sources of electromagnetic
noise. Conversely, this Class B digital apparatus complies
with Part 15 of the FCC Rules and meets all requirements of
the Canadian Interference-Causing Equipment Regulations.
However, if this control does cause harmful interference to
radio or television reception, which is determined by turning
the control off and on, the user is encouraged to try to correct
the interference by re-orientating or relocating the receiving
antenna, relocating the receiver with respect to this control,
and/or connecting the control to a different circuit from that
to which the receiver is connected.
Cet appareil numérique de la classe B respecte toutes les exi-
gences du Règlement sur le matériel brouilleur du Canada.
Radio Frequency Interference
Important Safety Information
It is your responsibility to ensure that this control is safely installed according to all applicable codes and standards. tekmar is
not responsible for damages resulting from improper installation and/or maintenance.
This is a safety-alert symbol. The safety alert
symbol is shown alone or used with a signal
word (DANGER, WARNING, or CAUTION), a
pictorial and/or a safety message to identify
hazards. When you see this symbol alone or
with a signal word on your equipment or in this
manual, be alert to the potential for death or
serious personal injury.
This pictorial alerts you to electricity, electrocution,
and shock hazards.
This symbol identifies hazards which, if not
avoided, could result in death or serious injury.
This symbol identifies hazards which, if not
avoided, could result in minor or moderate injury.
This symbol identifies practices, actions, or
failure to act which could result in property
damage or damage to the equipment.
Read manual and all product labels BEFORE using the equipment. Do not use unless you know
the safe and proper operation of this equipment. Keep this manual available for easy access by all
users. Replacement manuals are available at tekmarControls.com
Do not attempt to service the control. There are no user serviceable parts inside the control. Attempting to service the control
voids the warranty.
• It is the installer’s responsibility to ensure that this control is safely installed according to all applicable
codes and standards.
• Improper installation and operation of this control could result in damage to the equipment and possibly
even personal injury or death.
• This control is not intended for use as a primary limit control. Other controls that are intended and certified
as safety limits must be placed into the control circuit.
• Disconnect all power before opening the control.