Installation and Operation Manual

20 of 40© 2011 D 552 - 08/11
Setting Display
FLOOR LOW
The lowest recorded floor temperature measurement.
Touch the number and touch the ENTER key to
reset.
Access Level: Installer, User
Range: -76 to 149°F (-60.0 to
65.0°C)
Conditions: Setup menu setting SENSOR 1 or 2 is
set to FLOR.
Default: Not applicable.
HEAT W1
The total number of hours the W1 relay has been
operated for heating. Touch the number and touch
the ENTER key to reset.
Access Level: Installer, User Range: 0000 to 9999 hours
Conditions: Always available. Default: 0000 hours
COOL W1
The total number of hours the W1 relay has been
operated for cooling. Touch the number and touch
the ENTER key to reset.
Access Level: Installer, User Range: 0000 to 9999 hours
Conditions: Setup menu setting FLOOR COOL is
set to ON.
Default: 0000 hours
Monitor Menu (3 of 3)
Setting Display
ACCESS LEVEL
Selects the access level of the thermostat, which
determines which menus and items are available.
Access Level: Installer, User, Limited, Secure
Range: INST (installer), USER,
LTD (limited), SEC (secure)
Conditions: Adjustable only when thermostat switch
setting set to UNLOCK OR tekmarNet
®
system control
switch setting set to UNLOCK.
Default: INST
STATUS INFO
Displays the current status of the thermostat including
any overrides from the tekmarNet
®
system control.
Toggles between “Status Info” and the current
status.
Override W1 = The tekmarNet
®
system control is
either forcing the W1 relay on or off.
Cooling Floor = Floor cooling is in effect.
Toolbox Menu (1 of 3)