Job Record

1 of 2 © 2009 J 162 - 08/09
J 162
08/09
- Job Record
tekmarNet
®
4 Setpoint Control 162
24 V ±10% 50/60 Hz 2.2 VA 24 V (ac) 2 A
Power: Relays:
tN4 Setpoint Control 162
One Stage Heat / Cool
Feb 2006 Lot 1948
Meets Class B: Canadian ICES FCC Part 15
Cut jumper to isolate relay
For product instructions see brochure
Use at least 194°F (90°C) conductors
/
Control Name / Location Network Address
Model No. Heat / Cool Schedule No.
Connected to Zone Manager / Zone
(Bus:Unit)
162
Master or Member
Communication / Power tN4 24 Volt (C, R) Sensor S1
Source tekmar Model #
Location Location
Relays R1 R2
Source
Location
Wiring Colors:
R Red
C Black
tN4 Blue
Rh (Jumper)
R1 White
R2 Brown
S1 White
Com Black
Factory installed
Jumper R - Rh
(terminal 3 to 6)
To isolate Rh - R1 and
Rh - R2 contacts, cut
jumper and provide
separate power supply
to Rh (terminal 6).
DIP Switch Settings (circle / fi ll-in the correct setting)
None
tN4 System Control
Lock
Unlock
Item Setting
APPLICATION MODE
MODE OF OPERATION
SET
OCCUPIED
SET
UNOCCUPIED
SET AWAY
SET POOL OCCUPIED
SETPOINT MAXIMUM
HOT TUB MAXIMUM
DHW MAXIMUM
FLOOR MAXIMUM
POOL MAXIMUM
CYCLE LENGTH
DIFFERENTIAL
MINIMUM ON
MINIMUM OFF
HEAT SOURCE
Adjust Menu Settings:
Item Setting
EXCHANGE SUPPLY OCCUPIED
MAXIMUM SUPPLY
PRIORITY
RELAY 1 PUMP
RELAY 1 PUMP DELAY
RELAY 2 PUMP ON
RELAY 2 PUMP RUN TIME
RELAY 2 SAMPLE
SETPOINT DEVICE ENABLE
OUTDOOR
WWSD
WWSD OCCUPIED
WWSD UNOCCUPIED
CWSD OCCUPIED
CWSD UNOCCUPIED