Job Record

1 of 2 © 2009 J 161 - 08/09
J 161
08/09
- Job Record
tekmarNet
®
4 Setpoint Control 161
24 V ±10% 50/60 Hz 1.7 VA 24 V (ac) 2 A
Power: Relays:
tN4 Setpoint Control 161
One Stage Heat
Feb 2006 Lot 1948
Meets Class B: Canadian ICES FCC Part 15
Cut jumper to isolate relay
For product instructions see brochure
Use at least 194°F (90°C) conductors
/
161
Control Name / Location Network Address
Model No. Heat Schedule No.
Connected to Zone Manager / Zone
(Bus:Unit)
161
Communication / Power tN4 24 Volt (C, R) Sensor S1
Source tekmar Model #
Location Location
Relay R1
Source
Location
Wiring Colors:
R Red
C Black
tN4 Blue
Rh (Jumper)
R1 White
S1 White
Com Black
Factory installed
Jumper R - Rh
(terminal 3 to 6)
To isolate Rh - R1
contact, cut jumper
and provide separate
power supply to Rh
(terminal 6).
DIP Switch Settings (circle / fi ll-in the correct setting)
None
tN4 System Control
Lock
Unlock
Item Setting
APPLICATION MODE
MODE OF OPERATION
SET SETPOINT Occupied
SET HOT TUB Occupied
SET DHW Occupied
SET FLOOR Occupied
SETPOINT MAXIMUM
HOT TUB MAXIMUM
Adjust Menu Settings:
Item Setting
DHW MAXIMUM
FLOOR MAXIMUM
DIFFERENTIAL
HEAT SOURCE
EXCHANGE SUPPLY OCCUPIED
PRIORITY
RELAY 1 PUMP
SETPOINT DEVICE ENABLE