Install Instructions

ManualsBrandsTekmar ManualsHeating SuppliesRelay - 120 V (ac) coil

Relay 004 - 120 V (ac) Coil

Installation & Operation Manual

D004

05/11

Accessories

Replaces:01/10

D 004 - 05/11

The tekmar Relay 004 - 120 V (ac) is for

use in applications where device opera-

tion requires a voltage that differs from

the control’s built-in inputs or outputs.

They can also be used in applications

where the device operation requires a

higher current than the on board relay

is rated for.

Relay 004 is energized with 120 V (ac)•

Introduction

Features

Test button

Red LED indicator

Pluggable base

•

Beneﬁ ts

Mounts to TS35 DIN Rail

Pre-wire and test base before

plugging in relay

Replace relay without disturbing

wiring

•

Note

For 24 V (ac) coil relay see D003•

Summary of content (4 pages)

PAGE 1
D004 05/11 Relay 004 - 120 V (ac) Coil Accessories Replaces:01/10 Installation & Operation Manual Features Introduction The tekmar Relay 004 - 120 V (ac) is for use in applications where device operation requires a voltage that differs from the control’s built-in inputs or outputs. They can also be used in applications where the device operation requires a higher current than the on board relay is rated for.
PAGE 2
Installation The Relay base can be mounted directly to a flat surface, or onto a standard TS35 DIN rail. Follow local codes for installation of the relay and wiring. For class 2 circuits, no enclosure is required. For all other circuits, the relay should be mounted in an approved enclosure. Wiring connections are made at the base terminals and are checked with the relay unplugged. Relay pulls straight out of base. Base can be pre-wired and wiring can be tested before plugging in relay.
PAGE 3
Testing Push the test button on the front side of the relay to manually close the N.O. (Normally Open) contacts and open the N.C. (Normally Closed) contacts for testing purposes. Test Button The red LED indicator turns on when the relay coil is energized. This LED is visible as indicated through the top of the relay and provides visual verification when the relay is “on”. When the relay coil is “off” the LED will also be off.
PAGE 4
Specifications & Warranty Relay 004 (120 V (ac) coil) Literature Packaged weight Dimensions Approvals Power supply (coil) Relay contacts (max.) Relay contacts (min.) Ambient conditions D004, C004 0.4 lb (180 g) 3” H x 1-9/16” W x 2-3/8” D (75 x 40 x 60 mm) CSA C US 120 V (ac) +10%, -20%, 50 Hz 2.7 VA, 60 HZ 2.3 VA 10 A resistive @ 250 V (ac) N.O., N.C. 10 A resistive @ 30 V (dc) N.O., N.C.