External Laptop Battery User Guide

ManualsBrandsTekkeon ManualsBattery ChargerMP3700

MP3700/MP3450-10 User Guide

Summary of content (20 pages)

PAGE 1
MP3700/MP3450-10 User Guide
PAGE 2
PAGE 3
USER GUIDE Contents Overview..............................................................................................................................2 Getting Started ....................................................................................................................2 Unpacking myPower ALL Plus........................................................................................2 Getting to Know myPower ALL Plus .........................................................................
PAGE 4
Overview With myPower™ ALL Plus —the universal rechargeable battery featuring automatic voltage detection, you can power your laptop or other portable devices that require from 9.5V to 20V, plus power and charge just about any 5V portable device from the USB port. Simply connect myPower ALL to your portable device to extend the battery life. myPower ALL Plus automatically detects and sets the voltage for the connected device.
PAGE 5
Getting to Know myPower ALL Plus MP3450-10 MP3700 Capacity Display Button USB Port for connection to 5V device Charging/Power Indicator Capacity Display Indicators Power Battery Connection Port/ 3-Pin Input Port DC IN For connection to power adapter Battery Connection Port DC OUT For connection to device (9.5V-20V auto select) Storing myPower ALL Plus myPower ALL Plus can be used in the environmental temperature range between 32° to 104° F (0° and 40°C).
PAGE 6
Charging myPower ALL Plus myPower ALL Plus does not come with its own power adapter as it uses your laptop power adapter to eliminate the need to carry multiple power adapters. To charge MP3700, you can use either your laptop power adapter or a solar panel. The steps to charge with either of these devices are described in this section. myPower ALL Plus will charge in four hours when completely empty. The charging indicator will change from red to green after the battery is 80% charged.
PAGE 7
1. Slide the ON/OFF switch to OFF. 2. Connect the laptop power adapter to the DC IN jack on MP3700. If your power adapter tip does not fit the DC IN jack, connect the input adapter tip that fits your laptop power adapter to the plug on the laptop power adapter, and plug the other end into the DC IN jack on the end of MP3700. 3. Plug the power adapter into a wall outlet. The red charging indicator will turn on to indicate the battery is charging and is less than 80% charged. 4.
PAGE 8
To Charge through the DC IN Port 1. Connect the solar panel output cable into the DC IN port on myPower ALL Plus. 2. Verify that the red charging indicator turns on to indicate the battery is charging and is less than 80% charged. 3. When the charging indicator turns to green, press the Capacity Display button to view the battery capacity. If the capacity does not indicate full (all green LEDs on), continue to charge the battery until the battery capacity indicates full. 4.
PAGE 9
Using myPower ALL Plus The main output port (DC OUT) on myPower ALL Plus can be used to power and/or charge any portable device that requires between 9.5V and 20V (and some power devices that require slightly more voltage). At the same time or separately, the USB output port can be used to power and charge smaller devices requiring 5V. To use myPower ALL Plus to power and/or charge your device, take these steps which are described in detail in the following sections.
PAGE 10
2. Select the output adapter tip that fits securely into the power jack on your portable device. See Adapters on page 11 for detailed information about the adapter tips. 3. Connect the output adapter tip to the power output cord (but not the device). Connect the Power Output Cord 1. Plug the large end of the power output cord into the DC OUT jack on the end of myPower ALL Plus. Connect the Portable Device 1. Connect the output adapter tip into the power jack on the portable device. 2.
PAGE 11
Connect the 5V Device Using an Adapter 1. 2. 3. 4. Connect the compatible output adapter tip to the retractable USB cable. Connect the retractable USB cable into the USB port on myPower ALL Plus. Connect the adapter tip to your 5V device. Slide the power switch to ON to turn on the battery. While connected, myPower ALL Plus will power and charge your device. 5. Slide the power switch to OFF to turn off the battery when not in use. Connect the 5V Device Using the Device USB Cable 1. 2. 3. 4.
PAGE 12
View myPower ALL Plus Battery Capacity The capacity in myPower ALL Plus will decrease as the battery powers and/or charges your devices. The remaining capacity is displayed on the capacity indicator, which is accessed as described below. As the remaining capacity decreases, the lights will turn off in sequence from right to left. When the myPower ALL Plus battery capacity is low, only the red light will be on. You should recharge myPower ALL Plus at this time.
PAGE 13
Adapters Eight adapter plugs that fit most DC adapter jacks on a variety of laptops and a mini USB tip are included with myPower ALL Plus. The following table shows each adapter tip model number, marking, and compatible manufacturers.
PAGE 14
Sample markings for each type of adapter are shown here: Output Adapter Marking Input Adapter Marking If none of these plugs fits snugly into your portable device power jack, please go to our web site at www.tekkeon.com/mpadapters to determine which adapter plug you need for your device. You can obtain most adapters, including the Smart 3-Pin Adapter, through the web site, or by contacting Tekkeon by phone at 888-787-5888 or 1-714-832-1266.
PAGE 15
Accessories In addition to the adapters, several accessories are available for myPower ALL Plus, including: MP3300-10 Optional 3' straight output cable to extend reach between myPower ALL Plus and your device. MP3450-10 Extended battery that doubles the capacity of myPower ALL Plus (see next section). MP3450-30 Car charger to charge myPower ALL Plus. PA-CLA Female car charge that connects to myPower ALL Plus to charge your mobile device with your mobile device car charger.
PAGE 16
Using the Extended Battery (MP3450-10) You can double the capacity of myPower ALL Plus by adding the extra battery unit MP3450-10. When MP3450-10 is added to MP3700, the battery capacity shown on the indicators includes the capacity available with MP3450-10. Adding the Extended Battery 1. Place MP3700 on top of MP3450-10 with both flat silver ends facing the same direction. 2. Connect the bracket with the 3-Pin plugs inside to the silver ends of the devices.
PAGE 17
Troubleshooting If myPower ALL Plus does not power the portable device or charge the device battery, take these steps: 1. Verify that the battery is turned on by sliding the power switch to ON. Please note that with some laptop models, the laptop may shut down if the laptop is connected to MP3700 with the power switch in the ON position. Remove and replace the laptop battery to reset the laptop charging circuitry, and connect MP3700 again with the power switch in the OFF position.
PAGE 18
Limited Warranty The product enclosed herein is warranted to be free of operational defects for a period of one year from the date of purchase. In the event of a defect in operation during the warranty period Tekkeon, Inc. will replace the defective product when the owner returns all product contents. The limited warranty will be considered void if the unit is tampered with, subject to misuse, negligence or accidental damage, has been improperly serviced, or if the security seal is removed.
PAGE 19
Customer Support Customer support for myPower ALL Plus is available at: Tekkeon, Inc. c/o myPower ALL Plus 3002 Dow Avenue, #134 Tustin, CA 92780 888-787-5888 / 714-832-1266 www.tekkeon.com Tekkeon, Inc. must issue a Return Merchandise Authorization (RMA) number for all exchanges or refunds.