User's Manual

TEKCOM Industries Limited
Page 7 of 9
Skip
Press MON key and hold for more than 1.5 seconds, then press CH key to activate or
deactivate Skip function. Icon “ ” will be shown if activated.
6. Talk Botton
To talk, hold down the Talk. Speak into the microphone in a normal tone of voice when the
icons is displayed. When you finish speaking, release the Talk button.
7. MON Button / MCU Reset Button / Keylock
To hear everything happening on a channel, including weak transmission, hold down MON
button for more than 1.5 seconds. Re lease the MON button to turn the auto-squelch back on.
Holding the MON button while turning on the radio will resume your radio’s MCU and the quiet
code will be reset to number 12, QUIET privacy mode operation is deactivated, keypad lock
disabled, backlight switched off and channel setting will go to number 1.
When the unit is reset, memory channel M1, M2, M3 will go to CH1, CH2, CH3 without QUIET
code.
Your can also lock your radio setting to avoid accidental pressing of keys by activating the
keypad lock. Press and hold the MON button, then press the QUIET button to activate or
deactivate the keypad lock.
8. QUIET /QUIET Scan Button
Press QUIET button to enable or disable the QUIET privacy mode operation.
ａ） Hold down QUIET button for 2 seconds until QUIET is displayed and the quiet code
flashes.
ｂ） Repeatedly press (or hold down) CH or CH until you see the code number you want
to use.
ｃ） Press QUIET button to store the code.
To turn on the quiet feature, press QUIET. QUIET appears. To turn off the feature, press
QUIET until QUIET disappears.
Note: We recommend that you select a quiet code from the range 7-30. If you select a code
below or above that range, you must wait 1 to 2 seconds after holding down TALK before you
start talking.
QUIET Scanning
Press Quiet key for more than 1.5 seconds, then press “ ” for 1.5 seconds, quiet begin
scanning, scan icons of “SCAN” will be lightened on LCD. When received the same QUIET
code, the scanning stops and will keep scanning after the signal disappears. Press any key
will exit and return to the normal working channel.