User's Manual

TEKCOM Industries Limited
Page 8 of 11
Press the SCAN/DUAL button again to exit.
F. MEMORY CHANNELS
Using Memory Channels
The radio has 10 memory locations (00-09), to quickly access frequently used channels.
To access the memory channels, press the MEMO/M.PRG button. The LCD displays the channel
number on the left, and the memory location in smaller numbers to the right. Turn the CHL/SQL
knob to select a memory channel. To exit the memory channel mode, press the MEMO/M.PRG
button again.
Programming Memory Channels
To enter channels into memory:
1. Press the MEMO/M.PRG button.
2. Press and hold the MONI button then press the MEMO/M.PRG button. The memory location
number begins to flash.
3. Press the UP or DOWN key to get the desired memory location.
4. Press the MEMO/M.PRG button. The channel number begins to flash.
5. Press the HI/LO/BAND key to select either the USA, Weather, or International band for the
channel you wish to store.
6. Press the UP or DOWN key to reach the desired channel for this memory location.
7. Press and hold the MONI button then press the MEMO/M.PRG button to save the memory
location and exit programming.
8. To store additional memory channels, repeat the above procedure.
Press the MEMO/M.PRG button to exit the memory channel mode.
Scanning Memory Channels
To scan the memory channels, press the MEMO/M.PRG button, then press and hold the
SCAN/DUAL key for a few seconds. “SCAN” appears on the LCD as the radio scans the memory
channels, stopping on an active channel. Press the SCAN/DUAL key again to exit.