User's Manual

Page 7 Page 8
DSC /menu⑥ Use this key to enter Menu Setup or DSC Call Menu.
Call Mode is used for making DSC Calls. Menu Mode is
used to setup the radio.
⑦ Hi/Low/mem Press and release HI/LO button to toggle between
25watt power output and 1 watt output. “HI” or “LO” icon
appears on LCD display to indicate setting
Hold the key select memory channel mode
Scan⑧ Start and stop normal or priority scan and MEM
channels and priority channels scan.
Watch⑨ Start dual watch or tri-watch, Stop dual watch or tri-
watch.
16⑩ /9: Press and release 16/9 button to select channel 16 first;
further presses of 16/9 toggle between channels, press
16 key to quit all other modes and to into the channel of
priority.
DISTRESS This button is used to send a signal of distress in case
of emergency. See DSC Operation for details of
sending the call. This button is cover by a spring cover.
The Distress Function or any other transmitted DSC
function does not work unless a user’s MMSI has been
entered.
.
LCD: Large LCD (2“×1.5”) with viewable area of 4×12 dot
matrix makes it easy to be read.
Built-in Speaker Guarantee a clear ring and voice communication
2.2 BASE STATION (REAR)
① Antenna Jack: Connect a suitable antenna to your marine VHF
radio to get a satisfying communication.
② Power Source Connect the radio to a 13.8 VDC power source.
③ External Speaker Connection Cable If need be, you can also use this
cable to connect an external speaker.
④ GPS Connector Connect the radio to a GPS receiver to acquire
the position and time information of your vessel