Operation Manual

5
GB
Installation instructions
Use the “open” button to open the door and
remove all packaging materials. Then clean the
inside and the accessories with a damp cloth
and dry them. Do not use abrasive or strong-
smelling products.
Ensure that the following parts are in good
condition:
• Door and hinges
• Front of the microwave
• Inner and outer surfaces of the appliance
DO NOT USE THE APPLIANCE if you notice
any kind of defect in the aforementioned parts. If
this occurs, contact the Technical Support
Service.
Place the appliance on a stable, flat surface.
Fit the rotating base in the centre of the
microwave cavity and place the rotating plate on
top until it clicks into position. Whenever the
microwave is used, both the rotating plate and
the respective base must be inside the oven and
correctly positioned. The rotating plate turns
clockwise and anti-clockwise.
Warning! The microwave oven may be wrapped
in a protective film. Before switching it on for the
first time, carefully remove this film, starting at
the underside.
In order to ensure proper ventilation for the
appliance, install the microwave in a kitchen unit
with an opening on the top (see attached
sheets).
Warning: after installing the microwave, it is
necessary to guarantee access to the
electrical socket.
During installation, ensure that the power
cable does not come into contact with the
back of the appliance, because the high
temperatures may damage the cable.
If you are installing a microwave and a
conventional oven in the same column, the
microwave must not be placed under the
oven, because of the formation of
condensation.
The appliance must not be placed in the vicinity
of heating elements, radios or television sets.
The appliance is equipped with a power cable
and a plug for single phase current.
WARNING: The microwave MUST ONLY BE
CONNECTED TO GROUNDED ELECTRICAL
SOCKETS.
In case of fault, the manufacturer and the seller
will not accept any responsibility if the
installation instructions have not been properly
followed.