Assembly Instructions and maintenance recommendations Cooker Hoods CS-6000Using this instruction book Montageanleitung und Pflegehinweise Dunstabzugshauben CS-6000 Instructions d’installation et recommandations d’entretien Hottes aspirantes CS-6000
Safety instructions Dear Customer: Thank you for choosing our cooker hood. We are sure that appliance you have acquired will fully satisfy all your needs. This model is made using top quality materials and undergoes rigorous testing throughout the manufacturing process. Read this manual carefully before installing or using the product and faithfully follow the instructions in order to guarantee optimal performance of the appliance for many years.
Description of the appliance These hoods are fitted with A Light-switch B Sliding three-speed motor control switch C Operation indicator light D Controllable visor that enables better smoke collection (gases) E Filter body and supports F Filter support closures G Light-bulb illumination, over the cooking area and set behind a light diffuser K Easily extractable filter fitted in the lower part of the suction surface (optional) H & I Anti-return fins (H), included in the bag with the appliance documentation.
Special Requirements befo- How to use the appliance re using for the first time Suggestions and recommendations Before connecting the hood to the electricity mains, make sure that the mains voltage and frequency correspond to the values indicated on the rating plate inside the hood. • Switch on the extractor fan a few minutes before you start to cook (3 to 5 minutes) in order to ensure that a steady air flow has been established before cooking fumes appear.
Cleaning and maintenance BIFORE CLEANING AND MAINTENANCE, BE SURE THAT THE APPLIANCE IS DISCONNECTED FROM THE MAINS SUPPLI. Cleaning the filter support and the hood body • Limpieza del Filtro • • • Open the filter suppor t by moving the closures. Remove the support: take special care to avoid dropping it. Remove the filter by pulling it out and proceed with cleaning, either in a dishwasher or leaving it under hot running water, cleaning it with a non-abrasive brush.
If something doesn’t work Technical information Before calling the repairs service, make the following checks: Fault The hood doesn’t work Possible causeSolution Mains cable not connected Power not reaching plug Connect mains cable Check/repair mains supply Hood not extracting sufficiently or vibrating Filter saturated with grease Obstruction in venting duct Inadequate venting duct Clean or replace filter Remove obstruction Contact installer and follow the instructions in this manual Bulbs blown
Installation 530 168 When the hood is to operate at the same time as other appliances powered by any form of energy other than electricity, the air output pressure must not be more than 4 Pa (4 x 10-5 bar). 530 h To ensure optimum hood performance, the length of the venting duct should not exceed four metres and should not have more than two right angles (90º).
Extraction through the upper part (A) The system requires an outlet conduit. The gas extraction lever should be set in the position <> situated in the casing. An outlet tube (non-return) is fitted, checking to ensure that the other outlets are duly covered. 14 Re-circulation through active carbon Place the lever situated in the casing in the position <>, ensuring that the round cover is placed over the opening (A).
