User's Manual
Table Of Contents
- Overview
- Introduction
- Hardware Architecture
- User Interface Configuration
- Basic Configuration
- LAN Interface Settings
- WLAN Configuration
- WAN Configuration
- Services
- VoIP
- Advance
- Admin
- Statistics
56
TJ2100N-14ET User Manual
Enter the desired values by referring to UPnP configuration parameters table and
click on Apply Changes button to save the changes.
Table 25: UPnP configuration parameters
Parameter
Description
UPnP
Allows you to enable or disable UPnP by selecting the desired radio button.
WAN Interface
Allows you to select the WAN interface from the drop down menu.
RIP (Routing protocol)
Go to Service->RIP in the navigation pane. RIP Configuration page is displayed.
Enable the RIP if you are using this device as RIP-enabled device to communicate with
others using the Routing Information Protocol. This page is used to select the interfaces
on your device, and the version of the protocol used.
Figure 28: RIP Configuration