User's Manual
Table Of Contents
- Overview
- Introduction
- Hardware Architecture
- User Interface Configuration
- Basic Configuration
- LAN Interface Settings
- WLAN Configuration
- WAN Configuration
- Services
- VoIP
- Advance
- Admin
- Statistics
19
Following are some of the configurations required:
1. Basic Configuration
2. Configuration of PPPoE account (Internet)
3. Configuration of WiFi Service
4. IPTV service configuration
5. Phone(voice)/FAX service configuration
Basic Configuration
To perform the basic configuration,
1. Connect PC or laptop to any Ethernet port.
2. Configure a PC or laptop in DHCP mode and connect it to one of the LAN ports of
TJ2100N-14ET so that it gets an IP from the residential gateway.
3. Go to command prompt in connected laptop and check the received IP by typing
ipconfig in windows and ifconfig in Linux. It will receive an IP from class 192.168.1.1.
4. Open an Internet browser in the connected laptop/PC. Browse the following site:
http://192.168.1.1 the gateway config page is displayed.
5. Enter the user name and the password. The default user name is "admin" and its
password is "admin".
User Interface Configuration