TASC PRINTER MODULE INSTALLATION AND OPERATION MANUAL TASC PRINTER MODULE Connect To Serial I/O PRINT REQUEST SWITCH MIDWEST TECHNOLOGIES, INC POWER MID-TECH OFF ON FEED Spare Ribbon And Paper PRINTER (OFF / ON / FEED) SWITCH MIDWEST TECHNOLOGIES INC. - 2733 East Ash Street- Springfield, ILL. - 62703 999-1521 1 R1 VER 3.
TASC PRINTER MODULE INSTALLATION AND OPERATION MANUAL TABLE OF CONTENTS INTRODUCTION ........................................................................... 3 INSTALLATION ............................................................................. 4 SWITCHES AND CONTROLS 4 .................................................................................. 4 OPERATION ....................................................... APPLICATIONS 999-1521 ............................................
INTRODUCTION The TASC Printer Module has been designed so that it is simple to install and operate and rugged enough to stand up to normal field usage. The Printer Module provides an easy method for the operator to check the application rates entered in the TASC Console before starting spraying operations. The printer also provides a convenient written record of the spraying operation once it is completed. The written record can be retained in an appropriate file for future reference.
INSTALLATION Installing the TASC Printer Module is a simple matter of plugging the interface cable from the carrying case into the I/O port on the back of the TASC Console. The TASC Printer Module receives its power as well as data through the interface cable. SWITCHES AND CONTROLS There are only two switches and a power indicator light on the TASC Printer Module. 1. A rocker type switch on the printer is used to select printer "ON" or "OFF" or "Paper Feed".
MAINTENANCE General: Keep the printer and its connections clean. Close the carrying case when the printer is not being used. If the sprayer will not be used for some time, remove the TASC Printer Module and store it indoors (be sure to replace the dust cover on the Serial I/O Port on the back of the TASC Control Console if the printer is not plugged in). Replacing the printer paper: A red border on the paper tape used in the printer indicates it is time to change to a fresh roll of paper.
f. Pull the paper through the printer, until several inches are exposed. Carefully slide the ribbon cartridge over the paper and reinsert it into the print compartment. g. Slide the paper through the slot in the print compartment cover. h. Push the back of the print compartment cover down and into place. i. Press the front of the print compartment cover down until it locks into place. j.
Replacing the ribbon cartridge: An Epson Hx-20 ribbon cartridge is used in the printer. When the printing becomes faint or difficult to see, the ribbon cartridge should be replaced. NOTE: If the printer is used infrequently, the print mechanism sometimes becomes weak because the ribbon dries out. If printed material is difficult to read and you suspect this is the cause of the problem, advance to a properly inked portion of the ribbon by pressing the power switch into the "Paper Feed" position.
TROUBLESHOOTING a. Printer power light will not come on when the printer is turned "ON". 1. Check to be sure the TASC Control Console is turned "ON". 2. Check to be sure the interface cable is plugged in to the Serial I/O Port of the TASC Control Console. b. The TASC Control Console momentarily displays ERROR Message Err P when the print request switch is activated. The printer can receive no data from the TASC Control Console because it is busy controlling the sprayer.
