FITTING INSTRUCTIONS LH 1600 TRAM LINE MONITOR LH No. 010-152-UK LH Technologies Denmark ApS Mølhavevej 2 9440 Aabybro Denmark Tel. +45 9696 2500 Fax. +45 9696 2501 Internet: http://www.lh-agro.
FITTING INSTRUCTIONS LH 1600 KEY DRAWING 2 LH AGRO
FITTING INSTRUCTIONS LH 1600 FITTING THE MONITOR IN THE TRACTOR Mount the monitor in the cab within reach of the driver. Connect the monitor to the 12 V of the tractor via the 2-pole power plug A (fig. 1). Fig. 1 FITTING THE JUNCTION BOX Mount the junction box right in front on the drill. Mount it as protected as possible. When the cables later are to connect in the box the cable must be long enough to make a curve to ensure that water drips off and not runs into the junction box. (Fig. 2) Fig.
FITTING INSTRUCTIONS LH 1600 FITTING THE CLUTCHES AND THE CLUTCH CONTROLS Dismount the metering shaft and insert the two clutches (with feeder wheel and controls). Clutches and controls are mounted so that the core output turns down and the flat part of the housing makes contact with the hopper. Lead the supplied cables along with the chassis tube to the junction box. A metering shaft bearing shall be mounted as close to the clutch as possible.
FITTING INSTRUCTIONS LH 1600 FITTING THE IMPLEMENT SENSOR Mount the implement sensor so that it will register each time the drill is lifted (magnet and sensor must face each other for min. 2-3 seconds). Dependent on machine type and equipment there are various possibilities, say marker change, marker cylinder, lift cylinder etc. LH AGRO • The magnet can be glued on with suitable glue (Pos. 17). • Do not thighten the screws (pos. 15) too hard. • Relieve the sensor cable (pos.
FITTING INSTRUCTIONS LH 1600 FITTING THE WHEEL SENSOR Mount the wheel sensor on the "traction wheel". Use both supplied magnets to achieve a suitable wheel circumference. 6 • The magnets can be glued on with suitabel glue. • Do not thighten the lock nut of the sensor too hard. • The distance between sensor and magnet must be app. 5 mm.
FITTING INSTRUCTIONS LH 1600 FITTING THE TANK SENSOR (EXTRA EQUIPMENT) Mount the tank sensor app. 150 mm over the bottom of the hopper between the uttermost seed chamber in one of the sides. Drill a hole the size of which suits for the sensor. Screw it direct into the plate (do not thighten too hard).
FITTING INSTRUCTIONS LH 1600 ELECTRIC CONNECTION RELAY 6 5 1 Black RPM 1 2 Brown Clutch 1 3 Blue 0V 4 Yellow +12 V 1 White +12V 5 Black RPM 2 2 Brown 0V 6 Brown Clutch 2 3 Green 7 Blue 0V 4 Yellow 8 Yellow +12 V 5 Pink Tank 9 +12 V 6 Grey Implement 10 Tank 7 Blue Wheel 11 0V 8 Red Clutch 12 +12 V 9 Blue Implement 13 Blue Wheel 0V 14 Brown 0V 10 Brown Clutch RPM 1 Clutch RPM 2 LH AGRO Drill connection box Pos.
