Instruction Manual

Legacy 6000
98-05053 R2
73
Figure 3-28: Tilt Sensor System
Once the Tilt Sensor is installed and connected to the Legacy 6000, two initial
setup steps must be performed:
Antenna height entry
•
Calibration (level) of the tilt sensor•
To perform these steps, the vehicle should be situated on level ground.
Antenna Height
To access Antenna Height, select the System Setup softkey from the Main Launch-
er page. Select the GPS Receiver Setup softkey. Select the “Antenna Height” op-
tion on the GPS Receiver Setup menu and press Enter.
System Setup
softkey (F1)
GPS Receiver
softkey (F5)
Enter button