Instruction Manual
18
www.teejet.com
Fieldware
®
Link 4.02
►Section width (under Working width in Matrix Pro GS v3.xx) –
used to enter the width of each section of the implement.
Each section can be a different width. Sections are
numbered from left to right while facing in the machine’s
forward direction. Range for each section is 0.0 to
75.0 metres. Total for all sections must be greater than
1.0 metres.
►Spread length – used to enter the length of the
application section for each section. Each section can be
a different length. Sections are numbered from left to right
while facing in the machine’s forward direction. Range is
0.0 to 75.0 metres.
►Section offsets – used to enter the offset distance from
the leading edge of Section 1 (the spread offset line) to the
leading edge of each section. Section 1 is always 0.0 metres.
All other sections can be a different distances. Sections are
numbered from left to right while facing in the machine’s
forward direction. Range is 0.0 to 75.0 metres.
Job specic defaults
►Overlap – used to select the amount of overlap allowed when
the sections are turned on and off while using automatic
boom section control
Figure 40: Basic properties
Figure 41: Implement offset distance and direction
Figure 42: Machine settings – TeeJet spreader implement type