Instruction Manual

15
Fieldware
®
Link 4.02
98-05244-EN R1
Staggered implement type
NOTE: This profile type will be loaded on to the console as
“Straight”.
Basic properties
►Description – used to enter the name of the machine settings
prole.
►GPS antenna height – used to measure the height of the
antenna from the ground. Range is 0.0 to 10.0 metres.
►Guidance width – used to enter the distance between the
guidelines. Range is 1.0 to 75.0 metres.
►Implement type – used to select Staggered as the layout of
the sections for the applied product location.
►Implement offset direction  – direction from the centreline
of the machine to the centre of the implement while facing in
the machine’s forward direction
►Implement offset distance  – used to enter the distance
from the centreline of the machine to the centre of the
implement. Range is 0 to 10.0 metres.
►Section 1 offset direction – used to select whether section 1
is located in front of or behind the GPS antenna as the
vehicle moves in a forward direction
►Antenna to section 1 distance  – used to enter the
distance from the GPS antenna to the section 1. Range is
0.0 to 50.0 metres.
►Number of implement sections – used to select the number
of implement sections. When ABSC Enabled is unchecked,
number of implement sections is set to one implement
section and is unavailable for editing.
►Tank capacity – used to enter the capacity of the tank
►ABSC enabled – used to enable ABSC (automatic boom
section control) options
• Unchecked – single section setup options will be available
• Checked – Smartcable or SDM setup options will be
available (see “ABSC enabled – Smartcable or Section
Driver Module setup” section for details)
Implement dynamics
►Section width (under Spray width in Matrix Pro v2.xx
or Matrix Pro GS v2.xx, or under Application width in
Matrix Pro GS v3.xx) – used to enter the total width of the
implement.
Job specic defaults
There are no available options.
Figure 34: Basic properties
Figure 35: Implement offset distance and direction
Figure 36: Machine settings – Staggered implement type