Instruction Manual

12
www.teejet.com
Fieldware
®
Link 4.02
PROFILE OVERVIEW
Machine settings
A machine settings prole gives access to details about the vehicle
and implement including:
• Image
• Basic properties
– Each of these entries can be imported from machine
settings from the Matrix Pro GS v3.xx console, user dened
or user edited. Highlight and type over existing information,
use the UP/DOWN arrows or click the DOWN arrow
to make changes.
– Changes to Implement type and ABSC enabled will vary
the available basic properties, Implement dynamics and
Job specic defaults.
NOTE: Changing the description of a machine settings
profile does not change how a particular machine
settings profile is recognized by your Matrix Pro or
Matrix Pro GS console. If you are attempting to
create a new machine settings profile, please create
a copy or use the appropriate new machine settings
profile option.
• Implement dynamics
– Each of these entries can be imported from machine
settings from the Matrix Pro GS v3.xx console, user dened
or user edited. Highlight and type over existing information,
use the UP/DOWN arrows or click the DOWN arrow
to make changes.
– Changes to Setup type will vary the available Implement
dynamics.
• Job specic defaults
– Each of these entries can be imported from machine
settings from the Matrix Pro GS v3.xx console, user dened
or user edited. Highlight and type over existing information,
use the UP/DOWN arrows or click the DOWN arrow
to make changes.
NOTE: Machine settings are only supported in Matrix Pro v3.xx. An
error will occur when trying to export machine settings to
the Matrix Pro v2.xx format.
Implement type
Implement type selects the type of application pattern that most
closely represents your system.
• In straight mode – the boom sections have no length and are
on a line a xed distance from antenna
• In spreader mode – a virtual line is created in line with the
delivery disks from which the application section or sections
can vary in length and can be at different distances from the
line
• In staggered mode – a virtual line is created in line with
section 1 from which the application section or sections have
no length and can be at different distances from antenna
Section numbers
Sections are numbered from left to right while facing in the
machine’s forward direction.
Figure 25: Implement type - straight
5 4 3 2 1
Figure 26: Implement type - spreader
5
6
7
4
3
2
1
Figure 27: Implement type - staggered
5
4 3 2
1