Install Spra Coupe 44XX 4-Wheel User guide

www.teejet.com

FieldPilot

7. INSTALL PRESSURE AND EXCESS FLOW HOSES

Remove the steel line that goes from the Charge Valve to P port of the steering orbital. It may be necessary

to remove the hose and tting next to the P port to gain access to the P port steel line. Install tting (DD) in

port on the charge valve. Install hose (U) from the charge valve tting (DD) to the P port of the FieldPilot

Valve (G). Install hose (T) from EF port on the FieldPilot Valve (G) to the P port of the steering orbital.

Route the hoses along the right side of the support frame above the engine. It may be necessary to cut some

of the foam to allow room for these two hoses and cable to t properly.

Figure 1-12: Install Pressure and Excess Flow Hoses