Install Miller Condor Instruction Manual

FieldPilot

98-05160 R2

1. PrePare the FieldPilot ValVe

Install adapter (R) in the A, B, and T ports of the FieldPilot valve (C). Install adapters (S) on adapters (R) in the

A and B ports. Install adapter (Q) in the EF port. Install adapter (P) in the P port.

Figure 1-4: Prepare the FieldPilot Valve

2. PrePare the ValVe Bracket

Locate the front right cab support beam. Using the top of the two pre-drilled holes on the front edge of this support

beam, install bracket (I) as shown using bolt (G), two washers (B), and nut (H).

Figure 1-5: Prepare the FieldPilot Valve Bracket

G, B

& H