Install John Deere 9x00-9x20 User Manual

24
www.teejet.com
FieldPilot
®
13. INSTALL STEERING DISENGAGE SENSOR
The steering disengage kit (GG) is used to automatically disengage FieldPilot when the steering wheel is turned.
The sensor must be mounted so that it has a 1/8” clearance from the magnets. There are two mounting options:
1. Using self tapping screws, mount the aluminum bracket from (GG). Bend it as shown and mount the magnets
to the spokes of the steering wheel. Install the sensor and ensure the sensing tip passes over the magnets with
a clearance of 1/8”.
2. Remove the shrouds around the steering base. Locate the steering shaft and attach 3 magnets to the shaft,
then install the bracket and sensor as shown so that there is a clearance of 1/8” between the magnets and
sensor.
Route the cable and ensure it will not get tangled in any moving components. Connect the sensor to the SCM
harness.
Figure 1-26: Installing the Steering Disengage Switch (Kit 91-07011)