Install CAT C-D-E 65-75-85-95E Owner's manual
www.teejet.com
18
FieldPilot
®
11. INSTALL THE VALVE CONTROL CABLE
Connect the valve control cable (G) to the FieldPilot valve and route it to the bottom-right-rear of the cab and
into the cab.
Figure 1-15: Install the Valve Control Cable
12. INSTALLATION OF ENGAGE/DISENGAGE SWITCH
Connect item (A) to the connector on the SCM harness labeled Remote Engage/Disengage. Install the push
button in a location that is easily accessible during operation of the machine. This switch (A) is not required
if the optional foot switch 32-04020 is used.
Figure 1-16: Engage/Disengage Switch
Cable entrance
in back corner
G