User Manual

98-05047 29
R0
Quick Reference Guide
S
YSTEM
S
ETUP
M
ODE
• The Delivery switch must be off. Press
+
or keys
while simultaneously
pressing the
P
RO
key. Press the
P
RO
key again to enter the System Setup Mode.
Step Display Description My Values
Units
US, INP
Select US or Imperial gallons for your
application units by using
+
or keys.
Proceed to next step with
P
RO
key.
Flow Meter
Pulses
Flow Meter Pulses;
Value from flow meter label. Adjust by
using
+
or keys.
Proceed to next step with
P
RO
key.
Nozzle Spacing
Nozzle (or row) spacing;
Distance between spray nozzles or micro
tubes in inches.
Proceed to next step with
P
RO
key.
Tips per boom
section
SEC
1
# of tips or micro tubes on the machine.
Adjust with
+
or keys.
Proceed to next step with
P
RO
key.
Speed
Calibration
Speed Calibration. Change with + and -, or
to auto calibrate press + and -
simultaneously to clear value, then drive
300 feet and press
P
RO
.
Distance
Counter
Ft
Not a calibration step, but allows you to
measure distance in feet. Press
+
key to
start counting, press
+
key again to stop
counting.
Proceed to next step with
P
RO
key.
Simulated Speed
Enter the desired simulated ground speed
using
+
or keys.
Proceed to next step with
P
RO
key.
Communications
No con
Select the communications mode.
Proceed to next step with
P
RO
key.
Minimum
Pressure
Min prs
Sets the minimum pressure to which the
controller will regulate. The controller will
not regulate below this pressure.
• To exit the System Setup mode, press and hold
P
RO
for 3 seconds at any point in
programming process.